Vararam VR-B2 Bedienungsanleitung PDF herunterladen

VR-B2

Installation Instructions

(READ CAREFULLY BEFORE BEGINNING INSTALLATION!!!!!)

Tools needed for basic install:

1. Flathead screwdriver

2. 6-10mm sockets

3. Pliers

4. Ramps to lift front of car

PLEASE READ BEFORE INSTALLING!

1. This system is intended to enhance your vehicle and is in no way to be used for illegal racing on

public streets or highways. It is to be used on a race track or other controlled environment!

2. The new B-2 units are the 3

generation of the VR-1B, these kits have been made from modified

tooling to better enhance the ease of installation as well as improve overall quality of the product. We

have included some very useful helpful hints for each step of the installation, so please read the instructions

and the added tech notes carefully before beginning the installation process

Main Instructions

1. Disconnect the negative end to your battery

2. Remove factory air box

3. Remove factory radiator cross bar (4) 10mm bolts

4. From beneath the car, remove the air dam (2) 10mm bolts

5. Remove fan shroud (7) 7-8mm bolts, disconnect the air sensor from the shroud and pull shroud

forward to disconnect plastic tabs(these are located halfway up the shrouds front side) pull the shroud

out from the bottom of the car (pictures1&3). These tabs release with a twist, they are shaped like a half

C. You can also clip them off as they are used at the factory to hold the shroud in place as the car goes

down the line.

6. Remove the factory air box support screws from the cross-member (hex screws) located on the

frame cross-member (picture 4). These are the little nipples that stick out to hold the factory box in place.

You can use a towel and a pair of pliers to twist these out. If you do not remove these the ram tubes

WILL hit.

7. Remove front wire harness from the factory air deflectors (remember do not destroy these as you

will want to reinstall them later). These are plastic slide clamps, you can slide them to unlock them, and

they slide side to side to unlock.

1 2 3 4 5 6 7

Inhaltsverzeichnis

Seite 1 - Installation Instructions

VR-B2Installation Instructions(READ CAREFULLY BEFORE BEGINNING INSTALLATION!!!!!)Tools needed for basic install:1. Flathead screwdriver2. 6-10mm socke

Seite 2 - Cleaning the filter

Steps 8 and 9 are for cars with fog lights only!8. From beneath your car, on both sides of the shroud you will find 2 small access panels (5)7-8mm bol

Seite 3

Seite 4

Seite 5

Seite 6

Seite 7

Kommentare zu diesen Handbüchern

Keine Kommentare

Vararam VR-B2 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Vararam VR-B2 herunter. Vararam VR-B2 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Vararam VR-B2